ASTM A1125/A1125M-24 PDF
1.1This specification covers a group of common requirements that, unless otherwise specified in the applicable product specification, apply to wire rod for bridge cable wire.
1.2This specification is applied to wire rod with a nominal diameter of 11.0 mm [7/16in.] to 16.0 mm [5/8in.] intended for use in bridge cable wire.
1.3The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
